Control all your Sanyo TVs from one app

Yes. Our free Sanyo remote app discovers all Sanyo Roku TV units on your Wi-Fi network simultaneously using SSDP. Every TV appears in the device list — tap to switch between rooms instantly. Each connection uses HTTP REST (Roku ECP) (port 8060). No pairing code needed per TV on the first connection. No separate apps per TV, no subscription, and no limit on the number of TVs you can add.

All Sanyo Roku TV units on the same Wi-Fi network are discovered automatically via SSDP and appear in the app's device selector. Tap any to switch control instantly — the app maintains connections to all Roku OS TVs simultaneously so switching is immediate with no re-pairing delay. No PIN or pairing code is required — the connection is instant per TV on the very first connection only. Each subsequent connection is instant.

Our free Sanyo remote app supports multi-room control with no additional cost. All Sanyo Roku TV units on your home network are discovered simultaneously via SSDP. You select individual TVs from the device list — no simultaneous broadcast mode, but switching between TVs is instant. Each TV connects via HTTP REST (Roku ECP) (port 8060). No pairing code needed per TV on first launch. No subscription, no account, no limit on TV count.

None — the official Roku app instead. Funai publishes no Sanyo-branded remote app. On an FW Roku TV the first-party app is Roku’s, exactly as it is on the Philips sets from the same factory.

FW-series Sanyos follow the Roku convention: one button under the panel or on the rear. Short press powers on when the set is off; when it is on, short press opens the Input List and a long press powers down. Older non-Roku Sanyos instead carry a full button row, because there is no on-screen system to drive. On an FW Roku TV the network menu needs a remote or a phone — Ethernet is the way through first-time setup without either. On a pre-Roku Sanyo the button row is the whole interface and there is no network menu to reach.

The first thing to rule out on a Sanyo is age. Funai’s Roku line is recent; a Sanyo bought before it runs Funai’s own menu system and, on many models, has no network hardware to discover. No amount of router troubleshooting will make a non-networked panel appear. Check the model plate for the FW prefix and look for a Roku logo at boot. If it is an FW Roku set, the usual Roku causes apply — Control by mobile apps under Settings → System → Advanced system settings, and AP isolation on the router blocking SSDP. If it is not, infrared is the only route in.